Jonah
-
Posts
17 -
Joined
-
Last visited
Content Type
Profiles
Forums
Blogs
Gallery
Calendar
Downloads
Everything posted by Jonah
-
Thank you everyone for your suggestions but I figured it out. it was the receiver, Bought a new one, hooked it up, and flew into the sunset.
-
I'm not getting a new transmitter I'm getting a new receiver, I'm sure the transmitter is still perfectly fine because it is showing that it is doing everything it should do. I am going to try to get in touch with a local group. Thank you for your suggestion.
-
Okay thank you. I have registered it and updated it but no luck. I have sent Spektrum support a message and I am waiting for a response.
-
yeah it has probably been half a year since I used it last but it hasn't been in a crash. I'm ordering a new one to use for air planes and ill use this one for things that only need 2 CH. Thank you for your suggestions.
-
I am not sure how to add pictures to here but the first one is the one I have. the AR620 is not new but I have used it multiple times with drones and rc cars and it worked just fine. I'm saying out of all the ports only port 1 works for throttle and port 2 works for Ail and port 6 works for a second Ali when i set wing type to "2 ail and 2 flap." no i do not belong to a club.
-
I have the first one. In system setup there is no Channel Assignment, the closest thing is switch select but that only selects what switch does what.
-
Unfortunately I do not have another RX that can Bind with the DX8. I just find it odd that with all the settings reset and a blank model the only CH that react to anything are CH 1 and 2. I even tried re downloading the software for the DX8 but still nothing.
-
I have gone back to square one and Even when I start a brand new model with normal wing and normal tail the only ports on the RX are 1 and 2 with the throttle and Ail.
-
let me re phrase that, I am new to the world of custom made rc planes, I have a high wing trainer Rc and I build fpv drones. I have messed around with both modes and still nothing. The throttle works and when a esc is connected to receiver it works.
-
I have search high and low in my DX8 manual and in all the settings and can not find it.
-
All is not ok when I start from scratch... its like the RX is only getting aileron movement. Is there a way to hard reset a AR620 receiver?
-
Thanks for the suggestion, I don't see System Setup>Channel Assign in any of the settings. I have tried with a new model but nothing.
-
The only way I can get more then one servo to react is by setting wing type to "2 Ail and 2 Flaps" or " 2 Ail and 1 Flap" when I do this it lets two servos connected to CH 2 and CH 6 move and on monitor it shows RAL and LAL move when I move the aileron joystick.
-
yes, I have tried swapping the servos and same thing.
-
Thank you and yes I do have the DX8 manual, I have it all set up how the manual says to. I'm starting to think it's a receiver problem.
-
When I go into monitor it shows RAL and LAL moving when I move the aileron joystick so it is getting the right signals. but when i plug two servos into the ch2 and ch3 spot only the ch 2 moves.
-
Hello, I'm new to the RC world and trying to get a skywalker flying wing to work. I have a DX8 transmitter and a AR620 receiver, I have set the transmitter setting wing type to Elevon and plugged everything in. The throttle and port #2 works for one elevon but none of the other ports work. How am I supposed to plug the other elevon into the receiver? Any suggestions are appreciated.
