Bob H Posted May 19, 2012 Share Posted May 19, 2012 Hi Guys, On my new Easy Glider I am having difficulty joining the wings. Obviously where the wings join it is molded something like a jig saw piece to join the two wing halves. It seems I will have to use exessive force to join the two halves and I am afraid I would break the foam. Grateful for any ideas. Cheers, Bob Quote Link to comment Share on other sites More sharing options...
Ron Harrison Posted May 19, 2012 Share Posted May 19, 2012 No problem with joining the wings. Do it gently and with a little wiggle. Could be binding on the Spar so, put a bit, a wipe over with a cloth dampened with it, of Silicon, Back to Black, or Furniture polish. Put the Spar into one Wing, either will do, the Female first is what I used, and fit that into place and then the other, as suggested. It will ease up after a few Dismantles etc. I know because I had the same problem. Better tight than wiggly Ron Quote Link to comment Share on other sites More sharing options...
Broken Prop Posted May 19, 2012 Share Posted May 19, 2012 Hi Bob The wings on my EasyGlider were difficult at first, but after a couple of times they loosened up. Just make sure that the spar is not too long for the tubes. Good luck! Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.