John-Frederick Davie Posted March 8, 2016 Share Posted March 8, 2016 It is relativly easy to set-up Taranis in Trainer mode In this case My X9D was master and my friends X9D set as slave. However my X9D does not see the slave inputs when the two are connected. This is visiable in the Radio Setup Page4 Trainer. When linked the bottom line shows the Slave stick values and the cal can be run. With my X9D as master the values remain at Zero. Swap the status with my friend's X9D as master - mine as slave, all the values can be seem and call'ed correctly. We both run OpenTx 2.1 and I have reflashed my firmware all to no avail! Help!!! Quote Link to comment Share on other sites More sharing options...
GrahamC Posted March 9, 2016 Share Posted March 9, 2016 I managed to get mine to talk to a DX6i. I've not tried in version 2.1 through... This looks to be pretty helpful. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.