Geoff Bradley Posted October 18, 2008 Share Posted October 18, 2008 Hi - I'm new to RC aircraft and have just assembled a Seagull Rising Star but am unable to bind using the DX6i. The 'BindPlug' is female and the connection on the switch harness is also female. The bind plug appears to be a loop over the two outer connections which, if so, will have no effect (I think) as there is no cable connected to one of the outer connections.Can someone please help - so close to comleting the project but so far away ! Boo Hoo Quote Link to comment Share on other sites More sharing options...
Grant Darnley Posted October 18, 2008 Share Posted October 18, 2008 Is this a 6200 rx? If so follow the advice I was given in this thread solved my problems Quote Link to comment Share on other sites More sharing options...
Geoff Bradley Posted October 18, 2008 Author Share Posted October 18, 2008 Thanks Grant - the thread advice worked a treat.What a brill site - my first problem solved in no time.It's very frustrating that manufacturers sell products without thorough operating instructions. I've found similar with assembling the Seagull Rising Star and I purchased that because all the reviews said it had a good instruction manual. To a complete novice it certainly was not the case.I better go and try the engine now - fingers crossed Quote Link to comment Share on other sites More sharing options...
Former Member Posted October 18, 2008 Share Posted October 18, 2008 [This posting has been removed] Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.