Pete Norris Posted March 15, 2009 Share Posted March 15, 2009 hi guys i got a extra 260 with 120 four stroke in it .radio is dx7 and ar 7000 rx. can some one tell me how to mix the twin servos on the elavator so i dont need a reversing lead the lead makes the radio glitch big time what do i need to do with mixing so that both servos go same way when asked to would be well pleased to hear how to mix em both cheers guys Pete Quote Link to comment Share on other sites More sharing options...
Tim Mackey Posted March 15, 2009 Share Posted March 15, 2009 I doubt very much that "the lead makes the radio glitch big time". I suspect the reversing lead is making the servo twitch directly - something which a few folk have complained of. If you have a spare channel perhaps you could mix that to the elevator channel and plug one of the elevator servos into that - and activate servo reverse on that "spare" channel. I imagine that a spare channel should be available on a 7 channel Rx in that type of model. Alternatively, could you not refit the servos / horns so that one is effectively turning in the opposite direction - there was another long thread about this recently. Quote Link to comment Share on other sites More sharing options...
Bob Sims Posted March 15, 2009 Share Posted March 15, 2009 Hi Pete If you go into mix 1 then pick ELEV as the master then pick AUX2 as the slave Then set the RATE as +100 then pull the Elev stick to the bottom and while holding it down set the new rate to +100 Sorted if you need help PM me Bob Quote Link to comment Share on other sites More sharing options...
Pete Norris Posted March 15, 2009 Author Share Posted March 15, 2009 hey Bob what can i say it only works thanks for the tip will use it again if i need to cheers buddy . Pete Quote Link to comment Share on other sites More sharing options...
Tim Mackey Posted March 15, 2009 Share Posted March 15, 2009 Perhaps mix 5 or 6 may be better as this gives master /dual adjustment on the trim. Quote Link to comment Share on other sites More sharing options...
Pete Norris Posted March 15, 2009 Author Share Posted March 15, 2009 hi its me again i can only trim one side of elavorter have i done some thing wrong help lol Pete Quote Link to comment Share on other sites More sharing options...
Pete Norris Posted March 15, 2009 Author Share Posted March 15, 2009 hi thanks tim 5 is better trims both elavators cheers to you all Pete Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.