Rcslopesurfer

I can confirm that all servos are plugged into separate channels. left ail in Ail right ail in aux2. left flap in aux3 right flap in gear. I then set all surfaces to operate in the correct direction. Then add flap via flap system screen. As ail using aux 4 switch as the flight mode switch forward is reflex centre is norm back is thermal. It is at this point that it inputs aileron when the switch is operated rather than all surfaces moving up & down as they should. This had to be a glitch in the software as there's no fees able way if changing how it apportions the flap system there's no way of reversing it on any of the screens.

For sale jr xg11 like the futaba 12fg it's too complicated for this idiot

Is this setting in device SEL? Do I need to alter all rx plug positions to flap LV or Flap SW?

Hi guys I recently bought a radian pro to do a little bit of relaxing flying but am struggling programming my new JR XG11 tx to get crow braking & thermal flap & speed flap. I can't also add throttle hold in glider mode which is a huge shame. The problem I have is after getting all surfaces going the correct way I then add the speed flap setting & the surfaces on each side of the wing don't add flap they add aileron ie one side goes up the other down. I've speint 4hrs now messing with this & can find no way round it ive changed every conceivable plug combination & every time I end up with speed flap setting adding an ailleron command. Does anyone know if this is a glitch in the glider aspects if this radio? Or am I doing something wrong? Edited By Rcslopesurfer on 03/07/2013 09:47:04

Ahh we'll we will see I guess Dave I don't know too much more than what a few people gave advised me. I will take your advice & start at 3 mins I'll get the wife too time me

I'm expecting a minimum of 8 mins & to be fair it should easily do that. As for a first flight vid that's gonna be tricky but wait & see it may happen

I had looked at the 74" range mark but as this is my first real plane (not counting my wot foamies) after returning from helicopters I felt such a big beastie was probably not such a good idea so plumped for the smaller one & bought the xtreme wot 4 as an ongoing project. I also bought a hyperion sniper for some foamie practice 3d The 3d hobby shop stuff is superbly engineered & very very light. I think companies like sebart etc could learn alot looking at their range & the quality of it.

All ready for its maiden flight my 3d hobby shop edge 540 58" span Emax GT 4020/07 motor 6s 2600 gensace lipos 15x8 apce thin prop servos are hitec 5245 digital esc hobbywing platinum 100 lv just need some good weather & for this brisk wind to cease.

Well Ive taken it all out the box & this thing is just massive few nice touches in that the under cart is in two halves & theres a alloy spinner included in the kit. Engine ive bought ended up being the DLE 55RA as the 62 would just have meant cutting so much of the cowl away it seamed pointless. The build will start tomorrow one questionI have is theres realy no recomended servos on any literature Ive found for this model I am thinking about running some heli cyclic servos in it that are. Torque 6.0V: 166.6 oz-in (12.00 kg-cm 6.0V: Speed 0.08 sec/60° Any reason I cant use these metal geared Align DS 610 mg servos?