Keith....

hi i was recently given a powered glider and there was a graupner 700 turbo 9.v motor in it (all searches saying its a boat motor) and i want to change it for a brushless motor can anyone recommend a brushless equivelent ???

thanks bob

hi lads thanks for your help . i was back at it again today and i just set it up as a normal glider for the time being .i disconnected the flaps . i had followed the mixes off you tube but it didnt work ? im going to get it out a fly it and worry about crow braking another day CRISPIN CHURCH .. i thought i had given enough info im using turnigy gear meaning tx & rx are turnigy ? 9 channel and no there is no motor on it .. so now is that enough info ???

anyone ??????????

hi lads i recently built a mijet and im using turnigy radio gear.ive added extra servos to the wings for flaps and im trying to set up crow braking ive been on you tube to see how to do it but it doesnt say anything about the receiver ?? can anyone tell tell me what goes in to what channel for this to work ?? ive checked the turnigy manual but that doesent correspond with the programming of the tx ?? so if you can tell me where the servos are supposed to go and the programme mixes i should be using i would be very greatful ...

i happened to aquire one a few months ago .. it had been sitting in a attic since the late 80's early 90's and ive started to build it .they seem very rare and theres not a lot of info out there about them although they are very very similar to the phase 6 . i went slightly off plan and added servos into the wings for ailerons/flaps crow braking . put in sullivan snakes to control rudder and elevators .. so fingers crossed it will survive her maiden Edited By Keith Byrne on 17/07/2013 11:12:43 Edited By Keith Byrne on 17/07/2013 11:16:22