vic.l

I just tried your suggestion PatMc and accidently connected the esc plug wrongly,so the negative pin connected to centre and positive connected to signal pin on the receiver and now it's working.I've turned off/uplugged everything reconnected and it work's straight away. Many thank's to all who replied. vic.

Hi,All my model's are car's and truck's.The one I'm working on is a small scale excavator,which I was hoping to use esc's to control 6 functions.This esc is perfect as it is small and has reverse. Dave,servo's work fine on the throttle and my other model's,although they use different esc's work. Simon,My throttle is sprung to return to centre.I recalibrated the stick's yesterday. Thank's vic

Hi,Thank's to all reply's.I've tried again this morning with various setting's/different model type's and I still can't get it to operate on the throttle channel.The last thing I tried was to reassign the rx port's to the following: throttle to elevator elevator to throttle With esc connected to elevator,moving throttle stick operates esc. With esc connected to throttle,moving elevator stick does not operate esc. I have the throttle stick centered and the 2 receiver's I've tried are the orange r400 and 615.

I've tried reverse no change.The motors are brushed type and the batteries are AA ni-cad's at 6 volt.I just don't understand why the esc work's on the other channel's,but not on the throttle.I admit that I'm not fully experienced with radio's like the dx9,I've played with different setting's in the tx menu but I'm not getting anywhere with it. Thank's for the reply's vic.

Sorry I should have said in my post,servo's work fine on throttle channel.The esc only has a red light which when connected to other channels will flash then go steady when the stick's are moved,but on throttle it just flashes.I've tried calibrating,adjusting trim but it does not help.Other esc'c I have work without a problem.I've bound the receiver to a working model in the tx memory and still the same problem.

Hi,I have a esc which when connected to rudder,aileron or elevator channels it works as it should do,but when I connect to throttle nothing happen's.The esc make looks like a 'Hobbypower 10a'and my radio is a spectrum dx9 with orange receiver's.

I just downloaded the update again and the radio has updated.Not sure what was wrong but its all working now phew.Thanks for the replys. vic.

Thank's Romeo I'll try that tomorrow. vic

Hi,I tried to update my dx9 but it's now showing a system fault: T-code:00000A78h I-CODE:0303E000h sequence: 0 I tried removing battery,but it still says system fault.Can anyone help please. Thanks vic.

Thanks Pete.

Hi Could someone tell me if the dx9 has model match and does it require certain receivers to be used. Thanks vic