michael ray

Thanks both, will now get down to it.

Thanks Eric The contol run is supposed to be two pieces of pushrod fitted to each end of square section balsa, one of these being threaded for control horn. There was even four pieces of heat shrink provided to secure the wire. The elevator run was similar and easy to fit because it exited through the rear of fusalage. I think I will now use one length of suitable swg wire and solder the threaded piece to the end. Many thanks for getting my brain into gear

help please I have been given a Cherub R/C Electric Model Glider as a gift with the intention of perhaps returning to model flying, seemed a modest place to start. I can,t figure out how to get the rudder control run through the fuselage. I had no problem with the elevator run. Also how does one secure the motor inside. Be gently, I last built a Keil Kraft Luscobe Silvaire in the 50,s