stephen canham

Well my irvine 36 petrol engine is now on the plane so hopefully this weekend if weather is good i shall see how it runs/flies. let you all know how things went hopefully with a video aswell.

Hi Max, I also use the jst plugs on my nitro heli, Im useing 2200 lipos and dont have any problems.

Hi every one, Just to let you know iv had the irvine running on 15-1 mix but lost alot of top end power from 10000 rpm down to 850, So im thinking of going to 25-1, Any thoughts, Then please have a say, Cheers Steve.

Will have some more videos this week on my irvine convertion.

Anyone got an os 40 for sale.

Posted by onetenor on 30/04/2016 22:40:54: Try and contact Gear Best and Bang Good as I have seen the 1 cc car/ boat model one on one of those sites Best I can suggest at present or do a Google search Thanks onetenor, Think i will take the engine back too the shop and get something else, P.s i did look on google the only place i could find was for wholesale only.

Im looking for somewhere to get spare parts for a toki 40 nitro engine, Can anyone help.

Please subscribe to my youtube channel all links for videos are above, and you will get a free cable tie.

Also looking for a pumped carb for a 30 size.

I will be doing a conversion on my 600 helicopter from nitro to petrol some time soon aswell.

Posted by Philflyer on 29/04/2016 12:34:20: Remember Trigger's brush? I have a 16 year old MDS 40 that must have done hundreds of hours and is still a great engine. It's only had new front and rear bearings, a new needle valve, 3 carb O rings, a J'En silencer, 3 new con rods, a wrist pin and a piston and liner but it's still the same engine! Hi Phil, If the mds is working for you then you have run it in and set it up as you should, Nice one. Alot of poeple rush the running in process,

Posted by stephen canham on 28/04/2016 17:40:31: Here is the 1st video of the irvine 36 running. please note this is my 1st ever video, so please be kind. https://youtu.be/1YfnqU8Irao And here is the 2nd video https://youtu.be/sprhU_slRfI Please give a thumbs or down

Hi if watching my videos could please give a thumbs up or down.

Posted by Denis Watkins on 29/04/2016 10:51:06: Your innovation streak has served you well so far Stephen, and you are to be commended on your hard fought for success. The .36 would normally run on a 10 x 6 on glow, and it would not be a waste of time to unleash the revs on a lesser pitch prop. I bet you get your 12000 revs on a 10 x 6 - 11 x 6 prop. Best of luck Denis thank you very much, It feels good to have some positive feed back, I will be sure to let you know what the out come is when its all done and a longer video, Thanks again.

Posted by Bob Cotsford on 29/04/2016 10:05:31: 10k on an 11*8 from a .36 engine is pretty good for a start point. Thanks Bob, Still a little bit to do just waiting for a longer shaft to arrive, Then reset the TDC, And try it with a 15-1 mix, And see how things run.Hope to put a longer video on aswell.