Stephen farrar

Hi, I am attempting to install an A3 pro gyro into one of my planes. It's all, to me anyway, quite complicated. One thing I can't figure out how to do is assign a switch to it on my transmitter. It's a dx8 Any help much appreciated. Steve.

I have a turnigy G25 710kv motor which came apart as I was about to take off. The outer case with the prop shaft and outer magnets came apart from the windings and inner magnets part which remained attached to the fuselage. Any ideas why this would happen?

Hi, thanks for the advice. I will have a go at doing what is suggested. Thanks again. Steve.

Hi, I have several electric motors which have nothing on them to tell what size they are. Is there anyway of finding what they are?

Anybody got one of those hlk 31 pusher jets. Lots of scammer adverts selling them leading up to xmas at ridiculously low prices. Should be okay from banggood though I suppose.

Thanks for the advice. Building another one so will take your advise. Thanks again.

Propeller was 8x6 battery 2200mah 25c

Maiden flight of foamboard glider. Flying okay then 2 load bangs and it crashed in flames. 3 cell battery 30 amp esc 2240 kv motor. Any ideas what went wrong?

Hi, Got the Hobbyzone Delta Ray BNF for Xmas. Set up my dx8 as per instructions. Bound the dx8 to the plane. Safe setting works perfectly but I can't turn the Safe off for some reason. None of the switches have any effect on the Safe setting. Any ideas much appreciated. Steve.

Hi Graham, not seen that myself but it runs okay at full revs without the prop, not with, the motor completely stops when prop attached.

Hi Denis, The motor isn't spinning at all when the screaming noise starts, it stops completely.

Hi Gary, prop retained with one of those prop saver rings and it is gripping ok. Motor doesn't scream when no prop is on and that would be at its highest revs I presume.

Hi Denis, thanks for the quick reply. Unfortunately I'm not sure what you mean. I only replaced the motor like for like and the new motor did not come with any paperwork.

Hi, just installed a new replacement motor in my wing wing. Tested without propellor and all worked fine. But, when I put on the propellor and gave it full throttle the motor stopped and made a screaming noise. No burning smell or smoke. Removed propellor, gave it full throttle and all is okay. Tried with propellor, 5 x 5, engine stops at full throttle with screaming noise again, tried without prop and all okay, tried with 6 x 5 propellor, screaming noise at full throttle again with engine stop. Anybody any ideas as I'm stumped.

Hi,Yes I do have a bind, the control surfaces are working okay.The flashing red light is a differnt light to the bind light.I have tried a different esc from another plane and ythe throttle works just fine, as do the ailerons and elevator. Steve.