james brough

SORRY I POSTED IN WRONG PLACE BUT THANKS FOR THE IN FORMATION

hi peter miller on the front leading edge of the wing do you sand down the top and bottom overhang before gluing in the front leading edge and do you round of the front edge after gluing it on HELP

thankyou very much ron

hi folks when you fit the front leading edge strip does it follow the edge of the tip or does it sit on top of the tip and do taper it before you soak the end of the full strip regards jim

thank for that info peter its more clear in my head now with those pictures on the model flying site regards jim

hi its me again i am building the wings for ps2 at the moment but can only build one at time how far do i have to buid them before i join them together to complete them regards jim

hi thank you peter i shall get there in the end I HOPE regards jim

hi kc thanks for that have just looked again at the plan and found the info good idea of yous to use as well though thanks a lot regards jim

hi another query on peggy sue 2 cant see any reference to the elevator wire dimensions to join the two pieces together or what gauge to use any help would be very much appreciated regards jim

thanks very much for the info on the cowl i had cut a 1/32 ply so i cut another to glue together today depending on any replies now i can glue them up THANK YOU KC AND PETER MILLER

hi folks there was an picture in rcme recently of a cowl that had keyhole slots in it that slid down four screws in the firewall and was held in place by a swivel does any one remember how thick the ply face was the cowl was built onto with the keyhole slots in

thank kc i will try that starting tomorrow i hope

hi the printers i have used before does not do it now another one wanted £40 to do it i shall have to bite the bullet and trace it

thanks very much for that i get 2 copies of the plan local so i am sure they could do that

hi it might sound a daft question to you but i can only build 1 wing on the plan and building board so how do i get to build the other side to get all the parts in the right position I AM NEW TO BUILDING SO DONT LAUGH