GKM4

After checking thoroughly, I appear to have multiple Throttle cut of switches as in Switch H B and C. I have only ever set up switch H and this is a new transmitter. Very odd! Now I need to find out how to reset Flight modes and start again.

Thanks. That will be my "after dog walk" project this afternoon.

Have taken particular notice of this as I just cant fathom it out.

Just tried this and the servo connected to the Y lead, which is connected to throttle (Number 1 on receiver) works whether throttle cut is on or off.

I will try that this morning. Thanks for your help.

Thanks for this info. I was thinking along the lines of losing the dual rates and expo to see if that works. I have tried throttle settings of everything down to -130 but no joy. I will try again tomorrow. Thanks to all for the help.👍

Well I just reprogrammed safe and AS3X again which is about the 6th time I have done it and still no joy. The only difference this time is that when I advance the throttle, nothing happens but when I return the stick to the bottom of its travel, I get 1 beep now. I must have spent 4 or 5 hours trying to get this going. Beginning to look like I am returning to the wrong hobby.😩. As I say, before the forward programming, everything works perfectly and no steps in it have a direct input to throttle that I can see.

Thank you for your replies. I did a total factory reset on the transmitter and receiver last night and then did a fresh bind and set up of the aircraft inc dual rates, exponential and Throttle cut.Also voices to the switches that I used. All is working fine but now will go through Safe and AS3X set up again to see what happens. I will let you know.

Totally reset receiver again and all controls work including throttle. Went in to Forward Programming and set up Safe and AS3X again. Safe and AS3X working fine but no throttle. Monitor shows that all channels are working correctly and I have tried to reset the ESC but no bleeps or noises and no response. I am now assuming that due to the age of this model which is at least 15 years old the ESC is not compatible with the receiver although it works without the modes programmed in to it??? Any ideas?

Thanks for reply. Monitor showing that all is well. Just totally reset the receiver to factory default again and throttle works like a charm. I will try setting up safe and as3x again to see what happens. This time I wont set up throttle cut and see how it goes.

I did try setting the trim down a bit but it still did not work. I just reset the receiver and calibrated the ESC and the throttle worked but just reprogrammed the Safe and as3x and now it wont work again.🙄

I have just set up my AR8360T using my NX8. All I have done is set rates switches, exponential, safe and AS3X plus a throttle cut and now I have no throttle. Throttle is plugged into 1 on receiver as required. I have checked the throttle cut set up and it seems to be ok. Would an ESC fail just like that? Thanks for any help.

HI, First post on the site as i'm getting back into the hobby. I have an ST MX2 which I have resurrected from the garage and have installed an AR8360T in it. All was well until I programmed a couple of switch voice announcements (Throttle cut and Motor on) and also AS3X and Safe. All seemed well until the final test and now I have no throttle response which worked fine before the programming. Anyone have any idea what I may have missed which is affecting throttle? Its a long shot when you are not in front of it I know but I thought I would put it out there. Thanks for looking.