DG1000M

The fuselage is close to being finished, these photos show what has been done so far.

1/4" sheet plywood that will be used to build the U/C, will be attached from the firewall towards the trailing edge of the wing.

The fin and rudder are finished, 3/8" was used.

The tailplane and elevator are finished, 3/8" sheet was used.

the undercarriage is almost finished, the only difference going to make it a little stronger from the original plan. The main U/C are 3" wheels using 8 SWG, tailwheel has 2" wheel using 10 SWG.

After some thought, I have decided to place the elevator servo towards the tail keeping the arm movement short, a much better option.

Balsa Tint Model Lite filler, using this to fill some pin markings and tiny gaps, once lightly sanded, you are unable to see where any tiny holes are.

Both sides of the fuselage dry fitted to the servo and battery tray, just kept together with this masking tape.

The servo and battery tray are dry-fitted to the right side of the fuselage.

The servo and battery tray are finished.

Both fuselage sides are finished.

This photo shows what it will look like looking towards the tailplane.

This photo shows what the unit will look like when placed in the fuselage.

Top view of the same unit put together.

This photo shows what it looks like with both F2 and F3 put together, only dry fit.