Stephen Jones

Thanks Mike, I have updated the Firmware in my Rx and it now has bound with my Tx but my servos are not working. If I power down my Rx my Tx reports lost connection and if I power up my Rx it reports that it has recovered. I have programed my model memory to use D16 Steve

Thanks Mike 👍🏻 I will download and try the uni firmware. My Tx was bought as EU Lbt. I think I updated my radio some time ago but I have never flashed any of my Rx. They have just bond ok. Cheers Steve.

Thanks Brian I downloaded a firmware for the X8R from FrSky but it say its not compatible with 2.2.X . So a bit stuck as to where I can get the firmware from. Steve.

Hi, Hope someone can offer some help with a Receiver that will not bind to my Radio. My Taranis x9D is currently on v2.2.3 and all my current Rx work fine I recently bought a X8R ACCST Rx and it will not bind I already have a X4R and X6R they works fine. I think I am looking at updating the firmware in the Rx only so that I can preserve all my other Rx here is a list of what I have. Delta 8, V8R7-II, X4R, X6R, VD5M. I can not get hold of the VD5M any more and as I use these for my indoor models I do NOT want to do anything that would result in me not being able to use these little Receivers any more. I may have other types of Receivers as well. Its Just this X8R ACCST Rx that I need to work. Cheers Steve.

Thank You Steve

And some flexible foam too. I reckon you can get all you need from B n W .😉 White Depron foam and soft under floor foam. Steve 😊

Here is the Video, Enjoy I did. After much Trimming it flies great, Nice and Slow too. Steve.😃

Flew this model today. Complete success turning both left and right equally as well. Nice and slow flying video to follow. Well please with it. Steve 😊

Not yet, test flight soon 👍🏻

With Indoor season now upon us I have decided to build a few new models to fly in the Gym. Not everyone's cup of tea I know but it is for me 😜 So a bigger flying flea it is I have done a lot in the past but this time its going to be bigger. Made from Depron foam and a small amount of wood. Most of the foam is 3mm thick I may of gone over the top with the wood I used in this build. I could of remove some of the ply from the mast, Now only if I had a Lazer cutter. Due to its size and shape I decided to make it possible to disassemble and store in a box. So the wings come off for easy transport. This is the rear wing and the two inner ribs have a locating hole in them into which I insert a cocktail stick. On the rear sides of the body I glued two Ply locating supports . A little bit of trimming of the wing is needed here. Radio Gear now fitted a Brushless geared motor and two 3.7g servos. Added a bit of color. And done. Their are more pictures in my album if you wish to see them. Steve.