Ailerons not working correctly

[John Gallard]

I have had this problem before but cannot remember the solution. Spektrum AR6200 receiver, servos for both ailerons, dual ailerons selected, left aileron to aux1 and right to aileron port ( as per manual) A left bank drops the left aileron and raises the right, a right bank drops the right and raises the left. Reversing servos causes the ailerons to act as flaps, swapping servo leads makes no difference. Ths model has flown ok in the past, have simply changed designation of the model in MODEL select. I have seen suggestions to solve this prob but to no avail! Any help appreciated

[Bob Cotsford]

have you tried reversing the primary aileron but leaving the slave as normal? I use Futaba but I'd have thought the principle should be the same. With aileron diff, flaperons or delta configurations I set up one control surface at a time, start off with the 'master' chanel - in this case the servo on the aileron port, get this moving correctly then set aileron diff on aux1 to get the other aileron moving the right way. If I remember correctly this means that ch6 ends up with a -ve mix most of the time.

[Peewhit]

Hi John,

What transmitter are you using and what model designation have you selected?

[John Gallard]

Sorry for delay in replying. I returned to the problem this afternoon (left it yesterday in dispair) I started from scratch and after a couple of attempts now working ok, but I do not know what I have done differently

Thanks