Martin Whybrow Posted May 13, 2013 Share Posted May 13, 2013 I picked up one of these servo testers cheap at Old Warden yesterday, but there are no instructions with it and I can't find any by Googling; it has 2 modes, manual and auto, but I can't figure out how to put it in auto mode. Does anyone have the instructions for this? Quote Link to comment Share on other sites More sharing options...
WolstonFlyer Posted May 13, 2013 Share Posted May 13, 2013 Just looked this up on the Ripmax website but they don't have any info.It appears to only have two buttons and the LCD, so have you tried pressing the up and down arrow buttons at the same time to see if it goes into Auto test mode? If I was designing this device I might do the change from manual to auto mode by doing that. Quote Link to comment Share on other sites More sharing options...
Kevin Fairgrieve Posted May 13, 2013 Share Posted May 13, 2013 I too have one of this with no instructions. To date I have drawn a blank on the WWW. Would also like a copy of the instructions. Kev Quote Link to comment Share on other sites More sharing options...
Martin Whybrow Posted May 13, 2013 Author Share Posted May 13, 2013 I think I've figured it out; after connecting the battery, hold either button down and press the other button twice; that puts it in to auto mode. Holding one button down and pressing the other button once will return it to normal mode. When it's in normal mode, holding one button down and pressing the other once resets the PW to 1.5ms. I haven't connected it to a receiver yet, so haven't been able to check the test mode. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.