steve-richards Posted November 1, 2015 Share Posted November 1, 2015 A bit of problem i cant get my pc (windows 10) to recognize my transmitter Iv tried opentx and companion9 still no joy all i get in my device manager is STM devise in DFU mode Any help please Quote Link to comment Share on other sites More sharing options...
Andy48 Posted November 1, 2015 Share Posted November 1, 2015 Did you put the Taranis into bootloader mode first? (Hold the rudder and aileron trim in towards the centre whilst switching on.) It does work fine with Windows 10. Quote Link to comment Share on other sites More sharing options...
Dave Hopkin Posted November 1, 2015 Share Posted November 1, 2015 I found I had a few permission issues when I first went to Windows 10 - But once the updates had been installed its been fine Quote Link to comment Share on other sites More sharing options...
steve-richards Posted November 1, 2015 Author Share Posted November 1, 2015 Andy49 thanks I will give it a try Quote Link to comment Share on other sites More sharing options...
steve-richards Posted November 1, 2015 Author Share Posted November 1, 2015 What's the process to get into boot loader mode apart from the stick positions Quote Link to comment Share on other sites More sharing options...
Biggles' Elder Brother - Moderator Posted November 1, 2015 Share Posted November 1, 2015 Steve - its the trim switches you hold - not the sticks. BEB Quote Link to comment Share on other sites More sharing options...
Dave Hopkin Posted November 1, 2015 Share Posted November 1, 2015 Hold both Rudder and Aileron (mode 2) trim tabs into the center then switch on - then plug the USB cable in Quote Link to comment Share on other sites More sharing options...
steve-richards Posted November 2, 2015 Author Share Posted November 2, 2015 After iv put both trims in i get the boot loader and have three options i plug in usb and i get message on taranis and get usb conected then i get two screens on the computer whats next Quote Link to comment Share on other sites More sharing options...
Andy48 Posted November 2, 2015 Share Posted November 2, 2015 That's it you're in. The two screen show what files are stored: 1. In the Taranis memory. Don't do anything with that until you are sure you know what you are doing. 2. The contents of the SD card in the Taranis. I would copy the contents of the SD card onto your computer to give you a backup of the original settings. You should find quite a lot of useful info tucked away on this SD card. Next, install OpenTX Companion on your computer and use that to set up models and store them on the Taranis. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.