stevan Lewis 1 Posted August 13, 2018 Share Posted August 13, 2018 I have watched several videos of the sliders on Taranis and they travel from -100 to 0 to +100 when viewing on the monitor screen. When using the sliders on my x10 the travel is only from 0 to +100 and as the slide approaches the end of its travel it goes to 0 but then returns to 28. This happens for both left and right sliders. When I assign flaps these travel to the end but then return some. Is this normal for the x10 and if not should they be replaced? Any thoughts most welcome to help me with this issue. Also is this a FrOS issue as opposed to OPENTX. Steve Quote Link to comment Share on other sites More sharing options...
Chris Bott - Moderator Posted August 13, 2018 Share Posted August 13, 2018 Steve this sounds very much like a calibration issue. There must be a stick calibration procedure you can go through. I've no idea where this is in the FrOS menu system though, sorry.Edited By Chris Bott - Moderator on 13/08/2018 22:39:09 Quote Link to comment Share on other sites More sharing options...
stevan Lewis 1 Posted August 13, 2018 Author Share Posted August 13, 2018 Thanks Chris, you could be right, I will try it again tomorrow. Steve Quote Link to comment Share on other sites More sharing options...
stevan Lewis 1 Posted August 14, 2018 Author Share Posted August 14, 2018 Thanks again Chris, you were correct. I didn’t realise the sliders were also sticks and only calibrated the primary controls. All now hunky dory. Steve Quote Link to comment Share on other sites More sharing options...
Chris Bott - Moderator Posted August 14, 2018 Share Posted August 14, 2018 Good news. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.