Scruffmeister Posted November 17, 2019 Share Posted November 17, 2019 Just want to check this one, where a plan specifies dihedral, you would presumably measure this from the chord line if not specified? Below is the Chilli Wind plan I am working from, it does say "under" each wingtip so perhaps the intention is to put a 1" block under each tip when joining at the point shown on plan? I need to commit to an approach before I cut foam cores! Edited By Scruffmeister on 17/11/2019 21:16:04 Quote Link to comment Share on other sites More sharing options...
alex nicol Posted November 17, 2019 Share Posted November 17, 2019 Measure from the bottom of the thickest part of the tip rib to the desk. Also put one half of the wing on the desk and set the tip of the other wing to 2" from the desk, this will give you 1" under each tip. Is it a Chilli Wind by any chance? Cheers Alex Quote Link to comment Share on other sites More sharing options...
alex nicol Posted November 17, 2019 Share Posted November 17, 2019 Ignore the Chilli Wind question, senior moment on my part Alex Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.