andy harrold

Should there be as a space between the forgiven and the question mark?  I think not, but I may be wrong. Enjoying this spelin fred imense lee.  reguards two yew haul.

i had trouble getting the bind process to work with it all connected so i removed the esc as part of the diagnosis there is no ON-OFF switch in the circuit of the ESC so when i connect the lipo (deans connector) it cracks into life. should/can  i fit a switch?  the glider fuz has the fittingsalready there from the old esc. i think it will make it slightly safer for when someone has to recover the model on the rare occasion it hasnt landed at my feet!.  only joking!!

be careful with the failsafe. i today bound my new dx6i its receiver. i then connected the esc. the esc said there was a problem with the throttle servo and it needed reversing. No problems, so i switch off the dx6i. at which point failsafe cuts in,   throttle fully closed= max chat on motor!!!   Doh.   no blades on spinner so disaster averted, but be aware! i think the spektrum instructions are poor in that they assume you have a receiver battery attached which is not always the case.

Thanks for this post, I have a Nebila 2000e and am just about  to do the same conversion.  Has anyone else done one?      If so, what size motor, esc and prop have you used.    i was thinking of putting in a 2814/6 1410kv   ,  a 45a esc and using a 9.5 x 5 prop. but your sounds great so i might have to go back to the drawing board. i was hoping to buy a set up that could reused in a better glider should i bend/ wish to upgrade!

can i have it by Xmas!!

looks stronger than my 1000 piece jigsaw a k a my boomerang trainer!!