Simon B
-
Posts
2,218 -
Joined
-
Last visited
Content Type
Profiles
Forums
Blogs
Gallery
Calendar
Downloads
Everything posted by Simon B
-
Don't get me wrong, the BMFA HQ looks great, but this looks far more exciting. Shame it's in the USA!
-
I've ordered a motor and bits for folding prop from Gliders. This is the motor: Link Edited By Simon B on 19/12/2017 21:33:42
-
As you can see I have joined the sides. Found a few problems at the nose end where some of the formers haven't lined up, so I've had to break a few out and do some realignment. I'm planning on putting a motor in the nose, so I'm going to replace the two separate F1 pieces with a new single piece made from ply. Once it's all dried I'll get on with filling gaps with some scraps. Edited By Simon B on 19/12/2017 21:30:50
-
-
Your link doesn't work. I've got a shaft extender a friend made for me. Not sure on what motor at the moment, but when I've finished the second side I'll give it some thought.
-
I can't remember the AUW, but the projected wing loading was 16oz/sq ft. I'm planning on a motor I think. Something 500w should be about right. Maybe a 2200 mah 4s lipo
-
​
-
Second side planking starts today
-
-
-
-
Discovered i'd accidentally started too far over on the board...
-
-
-
Bit more progress. Now watching Christmas films while it all dries
-
-
It's been a crazy couple of months work wise and I need to wind down, so the garage heater has been fired up and I'm getting back to it eventually. Here's today's progress on the second fuselage side: Edited By Simon B on 03/12/2017 14:51:40
-
-
-
-
ST Blaze also worth a look
-
Started with ARTF, build and still use ARTFs too.
-
They went into administration. Their plans and kits side of the business was bought by Sarik Hobbies. There's a thread or two about it if you look through the search facility
-
Couldn't resist giving it a bit of a sand, even though I've got some planking to do still...
-
