Stuart Trump

Hi Geoff,see my recent posting on same subject.If you have digital servos I am told this is normal but if standad servos I would suggest they are trying oi travel too far or linkage is very stff Stuart

I have just completed the ST Speed Twin,yet unflown.I have used 9g digital servos and note that they seem to sometimes emit a noise around the centre point.Is this normal with digital servos. RegardsTo all and happy new year Stuart

Many of you have replied to my previous thread re twin ESC using a Y lead. I can confirm that cutting the middle lead on one esc made no differance as some suggested. Can anyone guide thro. the set up for using two seperate RX channels with mixing to achieve simultan.start up. My TX is a Futaba FF9 Stuart

Hi to all posting suggestions regarding my initial question re twin ESCs.Keep them comming. So pleased its generated so much discussion on the subject Stuart Trump

I am building the Speed Twin as the August RCME and having a problem getting 2 -25amp speed controllers to start the 2 tournig motors at the same time on the throttle stick,one starts approx two clicks behind the other.I am using a Y lead onto channel 3. Any suggestions would be helpfull Stuart

Just to say what a smashing plane inluded in the August RCME of the ST Twin electric.I had to build it and now approx.75% built with Eflite retracks fitted in wings following remarks in closing paragraph of report published. Retracks are very light but will Turnigy 2826/10 still be ok Regards Stuart Trump Edited By David Ashby - RCME on 25/09/2012 07:54:49