Hi all. Hope you guys are well. So, in 2015 I started building the Atom, but everything came to a halt after the birth of our twins. Recently, after being stuck at home after an operation, I decided to unpack my building stuff. All that was left to do, was make blades and cover the atom. The blades are getting me under though. Seriously. The three "blanks" weigh 27g, 26.9g and 25.8g. So, wood selection was okay. Off to shape them to profile. Dimensions are 60mm x 450mm. Actually not as difficult as I thought. Then I came to finding the chordwise Cog. And this is where I am stuck. The chordwise CoG is just too far back. Instead of the triangular FG plate I made the revised one from a pdf that I got from another site from Rich H. If I understand correctly, the mounting hole should be 430mm from blade tip, 1mm behind the chord wise Cog. In saying that, I suppose every blades' mounting point should be the same? I don't want to sand down too much more towards the rear of the blades, out of fear for losing profile. The Centre mark of the blades were all within 3mm so obviously my initial sanding was not too bad. Please help?