Ingrid Lunau 1

Hello, I have a powered Discus sailplane. The TX is a Spekky iX12. The problem I am having is that when I program the model under "sailplane". I wish to move the throttle control to the LHL, as the throttle stick will be used as per normal for sailplanes for the airbrakes. Unfortunately when you go into Assign next to throttle we have N/A, which means I cannot move the throttle control to another switch!! Anyone have any ideas? Robert

I have a DX10t transmitter bought new four or five years ago. This season I had a problem. Switch on the TX and a model, No response. So, I rebound the model, bound immediately, yet no response from the model! Tried a couple of other models, the same problem! I sent it to HH in Germany where I reside. Tx returned to me the the following week with this note, "System updated. Problem is a hardware fault. It is not repairable, because there are no spare parts available". I find this shocking, the TX is in as new condition, not used as much as it should have been, not that long out of production, now I am left with a beautiful TX that is useless! Would there be anyone in the UK who might be able to do something?

I have purchased some 6S Lipo`s which are fitted with EC5 connectors. I use X90 plugs on my models. They are compatible although the fit is not as tight as an X90 to X90 connector. Would this be OK or should I solder up some X90`s to my batteries?

Yes, I've used those but have not seen on this subject.

Hello Shaun, The receiver in my aircraft is one of the very latest models. It is the A637TA. So perhaps the instructions may not be suitable for my RX.

Hello, I have an iX12 Spektrum transmitter and the new E-Flite Viper 90mm jet. The problem that I have is assigning a switch to the gyro. I bind the plane in the SAFE mode, which is confirmed when the flying surfaces cycle twice after binding and when switching on. Howeverthe plane is in AS3X mode. I have switch "B" assigned for this, which is the norm for Spektrum models.. Asd many times as I try, it has no effect. All channels are set at 100% as required. Dnoes anyone have an idea what the problem may be?

Thanks to all

Many times

SHALL GIVE IT go. Thank you.

Many times !

Hello, Dont know if anyone can help on this matter. I have purchased an E-Flite 90mm DF Viper. I have bound the model to my DX9 in safe mode. However, I am unable to allocate a switcgh to this channel. These are the settings on my TX under Channel Assignments. 6 AUX1: Flap 7 AUX2: Aux 2 8 AUX3: Aux 3 9 AUX4: Aux4 Next: Channel Input config 6 AUX1: N/A 7 AUX2: E 8 AUX3: RKnob 9 AUX: B Channel 9 is the one that I have selected for the SAFE switch. Any helpwould be gratefully recieved. Robert

Ordered from Amazon today. Thank you.

I have several E-Flite USMX models that use 180mah 2S Lipo`s. The charger I have for these is no longer seviceable. I would like to purchase the correct socket for these cells, so that I can use my other chargers for these cells. Can any one help please.