[Oodalally - Build Log]

Hi Geoff

Have you forgotten me

Christophe

[Oodalally - Build Log]

Hi Geoff

i don’t think build a log but why not

I’ll would like make my laser machine in first time to cut parts of woods

christophe

[Cheap Chinese Laser Cutter]

Hi

are you sure about speed units ?

[Cheap Chinese Laser Cutter]

Thanks a lot for informations

christophe

[Oodalally - Build Log]

Hi

very good job 👍

i will make one as soon

have you got the file to put the laser diode

regards

christophe

[Oodalally - Build Log]

Hi

do you have a file of manufacture of your laser machine that interests me strongly the section mechanical and electronic

regards

christophe

[Cheap Chinese Laser Cutter]

Hello

how many passes does it take to cut 2mm balsa

Can you give your complete setup as well as the software you use for the cut.

Regards

christophe

[Cheap Chinese Laser Cutter]

Posted by ROBERT BURLACE on 22/09/2019 08:35:56:

A balsa rib - cut before I installed the air assist which really helps clean up cut edges.

Air assist - fed by a small pond air pump

Clean cut in some sample bits of 4mm ply - leaves a bit of a burnt edge but sands off easily enough and have had as bad on short kits purchased online before now.

And this is the setup - the bare aluminium rails are stock from the kit, i extended the cutting area using the black ones to 1100mm- giving a workable cutting area of about 400mm x 1000mm

Hi

have a link to buy the profiles of the building to enlarge the machine.

Christophe