Posted by ROBERT BURLACE on 22/09/2019 08:35:56:
A balsa rib - cut before I installed the air assist which really helps clean up cut edges.
Air assist - fed by a small pond air pump
Clean cut in some sample bits of 4mm ply - leaves a bit of a burnt edge but sands off easily enough and have had as bad on short kits purchased online before now.
And this is the setup - the bare aluminium rails are stock from the kit, i extended the cutting area using the black ones to 1100mm- giving a workable cutting area of about 400mm x 1000mm
Hi
have a link to buy the profiles of the building to enlarge the machine.
Christophe