christophe dauvergne

Hi Geoff Have you forgotten me Christophe

Hi Geoff i don’t think build a log but why not I’ll would like make my laser machine in first time to cut parts of woods christophe

Hi are you sure about speed units ?

Thanks a lot for informations christophe

Hi very good job 👍 i will make one as soon have you got the file to put the laser diode regards christophe

Hi do you have a file of manufacture of your laser machine that interests me strongly the section mechanical and electronic regards christophe

Hello how many passes does it take to cut 2mm balsa Can you give your complete setup as well as the software you use for the cut. Regards christophe

Posted by ROBERT BURLACE on 22/09/2019 08:35:56: A balsa rib - cut before I installed the air assist which really helps clean up cut edges. Air assist - fed by a small pond air pump Clean cut in some sample bits of 4mm ply - leaves a bit of a burnt edge but sands off easily enough and have had as bad on short kits purchased online before now. And this is the setup - the bare aluminium rails are stock from the kit, i extended the cutting area using the black ones to 1100mm- giving a workable cutting area of about 400mm x 1000mm Hi have a link to buy the profiles of the building to enlarge the machine. Christophe