Another Terry

Hi Mike I was after the R3106SB and found one that had just come into stock. I was told end of December/early Jan but some stock does trickle in now and again. Terry

I cannot get my Futaba GYA 460 to work with my 10J transmitter and R3008SB or R3106 receivers. 10j set Ch 5 to switch E 3 position. Tested by putting a server on the receiver output. End Point Ch 5 to GER Gyro Sens Type to GY etc. Cable - Receiver AIL1 to Gyro ALI1 Cable - Receiver GER (ch5) to Gyro Mode 1 Turn on Gyro Led 1 flashes Green then Goes Red ie No Signal. Have set "Install direction" and "Wing Type" Still LED1 stays Red. Am I missing something? any help would be appreciated.

I just used Oracover for the first time. When I unrolled it, the backing and film were already seperated. The Oracover www say use two pieces of masking tape to seperate the film from the backing. It seems to stick ok at 90 deg and stretch at 130 deg. Is the separtion usual or have I been sold some seconds or worse. Thanks in anticipation. Terry

Can anyone supply a wiring diagram so I can make up a Y lead for the Flaps on the Lil Cub. I have seached the www and can only buy ready made ones.