Hi Gary, I have recently started making the Ballerina, and just about to complete the first Wing-half. Although it is not immediately clear if I have made a mistake or not. On the most inboard rib R1. Should this have been slightly angled in anticipation of gluing the two wing halves together? I in the end made a full Size Rib, I think same size as R2, as I am using individual Slimline Wing servos so Ailerons will be run on seperate channels. But My R1 rib is already glued in at 90 degree from the board. Im now thinking that when I bring the two wing halves together that this is the main gluing face, and just wondering should I cut this rib back out and reglue it at an angle.
Hope you're still active on this forum, as your experience would be greatly appreciated.
Best regards
James