Bing

Has Spektrum repairs moved to Germany?

I've contacted Horizonhobby and we will see what they suggest.

Cheers Andrew, I've just checked back and found the set is just out of warranty so I'll be looking for a different battery so I can charge outside of trannie and see what is happening.

Its the battery that came with the set

just tried to switch on trannie at home still not working so connected to charger and it immediately came on showing 7.4 v then dropped to 7.2 after switching charger off. All limits were set but nothing was observed during flight and there was two of us there.

As I said before after charging there were no issues.

learnt a hard lesson today when trannie failed when aircraft in flight, aircraft a total loss, lipo burst into flames and burnt out the wreckage. It happened when the trannie screen went blank during the flight and I lost control will investigate further and try to discover what happened.

It was a new transmitter that would not switch on.

I recently bought a new DX7 gen2 Transmitter and have been using it for a couple of months but have found that when setting up controls on aircraft suddenly it will not switch on, this is after a flying after an hour or so. I've checked the alarms are on for low battery but receive no notification from transmitter that the battery is low and when recharged it operates perfectly is this (normal)?.

Can you recommend a outrunner for Ton Van Munsteren's P51

It's a touch of the sun, by the way thanks for the prezzie its was a welcome surprise.

I had excactly the same thing that happened to me in fact I could have written the same report. I had the Eco-Cam connected at the time, I asked the 'Forum' at the time they couldn't come up with why?.I never used the Eco-Cam again.

Would it be ok using a spektrum dx7 as master with dx6i as slave?

Thanks Engine Doctor can't give you any info on engine performance yet as its sitting on it's test bed ready to run in. But I'll bear in mind your advice when it goes into the model.

Hi All, anyone got any ideas on how to connect the throttle and choke on a crrc 26r as they appear to be in line with one another?