chrisw

hi ian yes it is the gain, if you look in your manual it will tell you how to set it, if your tail is viabrating it is what they call a loose tail, i'm not sure off the top of my head but i think you need to put in less gain ie turn screw to left. the thing with the cx2 the gain & proportional pots are labeled wrong ie the gain pot is the pot nearest to the motors that says proportional, as i said this is infact the gain pot. go to the following URL for manual if you don't have 1. http://www.scribd.com/doc/13586/Blade-CX2-Manual

hi ian take a look at my previous thread it explains that you need to set the gain, this is done in very small increments. chris

Hi Si I had the same problem as your having with the trim, I had a big crash from about 40ft up, all I had left was the main unit. I upgraded with the lloy bits to. When I came to test fly the heli I found I coundn't trim it up, what I found was if you set the alaron and elevator trim to center, then adjust the servo linkage arms until the heli is near enough trimmed then fine trim it on the TX. I also found I had to adjust the gain and proportional pots, this is done a tiny bit at a time, don't forget to re-arm the heli when you make any adjusments to the pots. Hope this helps Chris.

hi elliot nice light set, would you be kind enough to tell me in some detail how you desighned and built them. also how you run then on your chanel 5 on tx thanks very much chris.