Delta Whiskey Posted December 17, 2011 Share Posted December 17, 2011 Anyone point me to where I can get one of these U shape nose wheel frames for a 3 inch wheel? The threads for the grub screws are shot, and not holding enough. It also needs to fit the 6.4mm steel shaft or would this be a custom job? Quote Link to comment Share on other sites More sharing options...
ken anderson. Posted December 17, 2011 Share Posted December 17, 2011 hello delta...can you borrow a set of 'taps and dies' and repair the thread...may save you a bit of hassle..... ken anderson ne..1 ..taps and dies dept... Quote Link to comment Share on other sites More sharing options...
Alan Cantwell Posted December 17, 2011 Share Posted December 17, 2011 i agree, get the threads tapped out bigger, or fit helicoils, if you are not able, it would not cost a lot to get it done by me, but not this side of christmasEdited By Alan 4 on 17/12/2011 19:32:50 Quote Link to comment Share on other sites More sharing options...
Delta Whiskey Posted December 19, 2011 Author Share Posted December 19, 2011 There's not much space left for newer holes, as you can see I did make some more smaller holes with an electricians tap I had but it's really too small, I'm wondering if it may be better to just get it welded on? What are helicoils btw ? Quote Link to comment Share on other sites More sharing options...
Cyclicscooby Posted December 19, 2011 Share Posted December 19, 2011 If you do find a replacement, i'd love to know where you get it.. It's a lovely looking structure, and something i've only achieved by filing big lumps of ally.. Would be ace to find a supplier.. Luv Chrisie.. xx Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.