Allan Bennett Posted May 30, 2017 Share Posted May 30, 2017 The X4R receiver can output 11 channels if one uses it in CPPM mode -- i.e. channels 1-8 through the CPPM connection, and three PWM channels through the remaining three outlets. But, to set the receiver into CPPM mode, rather than simple 4-channel PWM mode, one has to put a jumper across the signal pins of channels 2 and 3. So far so good. But after binding can one remove the jumper? If not, how are you able to use channels 2 and 3? Quote Link to comment Share on other sites More sharing options...
MattyB Posted May 30, 2017 Share Posted May 30, 2017 Yep, the jumper is only needed for binding Allan. Quote Link to comment Share on other sites More sharing options...
Allan Bennett Posted May 30, 2017 Author Share Posted May 30, 2017 Thanks Matty. I'll remove it from the receiver in my quad then! Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.