Stuart Marsden Posted February 6, 2018 Share Posted February 6, 2018 I have one of these superb models and fly indoors within a gymnasium. All is well but there are quite a few midairs etc. Parts are available and I am about to start cutting. Ideally my repair is going to give long term access to the inside of the model. There must be a good few of you having already done this. Your ideas please. Cheers Stuart Quote Link to comment Share on other sites More sharing options...
Denis Watkins Posted February 6, 2018 Share Posted February 6, 2018 Usually, I just cut a straight line to seperate the cowl, then tape back Spares here **LINK** Quote Link to comment Share on other sites More sharing options...
Stuart Marsden Posted February 6, 2018 Author Share Posted February 6, 2018 Thank you, this is what I have done so far, rather than tape, I have used Por, but I fancy a little screw based solution. Perhaps I am being fussy and should just expect to tape, bash and tape again. Cheers Stuart Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.