AVC Posted July 6, 2018 Share Posted July 6, 2018 I have a Futaba 6EXA and I have bought the FRSky diy module to convert it to 2.4 (this one). Has anybody used it, and if so, are there any advices or comments? The instructions are quite vague. Also, I'm not planning to switch between 35 and 2.4. Is there any way of getting rid of the switch? Quote Link to comment Share on other sites More sharing options...
Mike Blandford Posted July 6, 2018 Share Posted July 6, 2018 The switch is to select the mode of operation: 1. Old "V" receivers (not "V-II" receivers). 2. "D" (telemetry) receivers and "V-II" receivers. 3. Firmware upgrade. Mike Quote Link to comment Share on other sites More sharing options...
AVC Posted July 6, 2018 Author Share Posted July 6, 2018 Thanks Mike, I read somewhere that it was to switch between modulations! Quote Link to comment Share on other sites More sharing options...
Fun Flyer Posted July 6, 2018 Share Posted July 6, 2018 Have a look here AVC... **LINK** Quote Link to comment Share on other sites More sharing options...
AVC Posted July 6, 2018 Author Share Posted July 6, 2018 Thanks Fun Flyer, I see that you went down the same route. After a couple of years with the FRSky module, have you had any problems? Once that I kick it off, I may contact you for advice Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.