Allan Bennett Posted April 28, 2021 Share Posted April 28, 2021 I've just updated my X9D Plus mode 3 trannie to V2 firmware following advice in this thread, but the electronics thinks it's in mode 1 and I can't change it to mode 3. In the Radio Setup screen I've set Default channel order to AETR and the Mode to 3, but it still thinks that the right stick up/down is the throttle, for it gives the "Throttle warning" message when I power up, and the wrong channels respond in the Channel Monitor screen. I suppose I could untick the 'Throttle warning' box in the OTX Companion setup screen, and then simply figure out which channel responds to which at the receiver, but that'll mess up other programming such as the throttle-cut function. Quote Link to comment Share on other sites More sharing options...
Bob Cotsford Posted April 28, 2021 Share Posted April 28, 2021 (edited) Allan, is mode 3 throttle right? Might be worth seeing what happens if you set it for mode 4. Edited April 28, 2021 by Bob Cotsford Quote Link to comment Share on other sites More sharing options...
Allan Bennett Posted April 28, 2021 Author Share Posted April 28, 2021 Bob, I've just twigged -- I fly mode 2, not mode 3! Setting it to Mode 2 and AETR has sorted it! Sorry to have bothered you. 2 Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.