Graham Jones Posted September 23, 2021 Share Posted September 23, 2021 Hi , trying to assign a channel for a reflex gyro, l am using a T16sz and rec r3008sb , not done this before thanks in advance. Quote Link to comment Share on other sites More sharing options...
John Lee Posted September 23, 2021 Share Posted September 23, 2021 It should be very straightforward, though I've done it with Jeti, not Futaba. Simply assign a 3 position switch to Channel 5 to control the gyro function (Linkage menu>Function in Futaba, I believe). Then use sBus and a single 3 wire cable between your Rx & the Gyro and it should all work. See the first diagram in the instructions appended below. Manual for Reflex system -four languages (2).pdf Quote Link to comment Share on other sites More sharing options...
Graham Jones Posted September 23, 2021 Author Share Posted September 23, 2021 I will try that many thanks ? ? Quote Link to comment Share on other sites More sharing options...
Graham Jones Posted September 23, 2021 Author Share Posted September 23, 2021 4 hours ago, Graham Jones said: I will try that many thanks ?? All done I hope Thanks again ? 1 Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.