Craig Carr
-
Posts
1,329 -
Joined
-
Last visited
Content Type
Profiles
Forums
Blogs
Gallery
Calendar
Downloads
Everything posted by Craig Carr
-
-
-
-
-
Hello Martin just balanced mine. With a 5000 4s turnigy pack it will balance (Slightly nose heavy) without lead if the battery is pushed right forward Craig
-
-
Tony's F-86 Sabre Build
Craig Carr replied to Anthony Crawford's topic in PSSA Mass Build 2020 - North American F-86 Sabre
Hello Anthony, some great work. Re your comment about producing a bevelled edge to planks all I have done is glue a piece of hardwood to one side of a standard balsa stripper. I then only use the slec balsa stripper aluminium guide as a straight edge to hold the sheet and stop the planks drifting off true. It does help, hopefully pics below help demonstrate what I mean. Craig Edited By Craig Carr on 24/05/2020 21:52:29 -
I got the fitting from an electronics shop near where I live (ESR in cullercoats) to make up a charging lead. I’m not keen on constantly removing the battery in case constant unplugging weakens the connector in the TX😬☠️
-
-
Phil's F-86 Sabre build thread
Craig Carr replied to Phil Cooke's topic in PSSA Mass Build 2020 - North American F-86 Sabre
Posted by Callsign Tarnish on 23/05/2020 20:21:05: Best resin I've used Plus one Been using it for years now .... best of the best cracking modelling work there phil -
Thoroughly enjoyed re-reading this thread again. Can’t believe 7 or so years have passed since I destroyed two pushy cats in quick succession due to my own stupidity have been tidying the workshop today and found the Traplet plans... very tempted to make another Edited By Craig Carr on 23/05/2020 19:07:29
-
-
-
-
-
-
airtek hobbies good service
Craig Carr replied to Geoff Parkes's topic in R/C Retailers / Distributors / Manufacturers
Another shout out for Peter at airtek... got some servos delivered today with the usual prompt efficiency the site also seems to have real time stock monitoring which is brilliant.. (had a couple of instances lately with other suppliers who’s site says an items in but it isn’t ... my pet hate) well done Airtek Craig Edited By Craig Carr on 21/05/2020 19:42:04 -
I’m awaiting the batteries but I must admit there’s a lot of tail weight. I’ve made the battery area to allow it to go forward as far as possible. How did yours balance Martin. Did you need the dreaded lead ?
-
Eventually finished mine today... just a rudder servo to add and balance the model. the decals were from Callie graphics in America. Can’t recommend them highly enough. Just over £20 for design, scaling, printing and postage to uk. Fast delivery as well.
-
-
-
-
-
-
