Alan

71 & 80 for me

12 for me

32 for me.

I have one or should I say HAD one.... in the repair shop. Brain froze at the wrong time.   Very nice plane to fly, handles superbly in the wind. The only thing i would say is mybe get some decal on the bottom off the plane as it is pure white and can be hard to see in distance.   My set up-   MOTOR Eflite power32E ESC CC ice 75amp BAT 4cell 3900's SERVO Hitec HS225MG all round

I agree with Allan thanks for the link to the to The Battery University, Tim.   also Allan definitely not put off just so much to learn in this hobby.  

Thanks for all your replies.... got alot of usefull info.   Alan

I understand that 1C charge is good for them. But what about when you cycle them what would be a good value for discharge and also voltage setting.   Alan

just wondering what would be a good discharge setting for this battery and also cut off voltage.   also how often would you cycle your battery.   Alan

Posted by Tim Mackey - Administrator on 26/03/2011 21:56:07: Yup - I use them all the time.     Thanks was not sure about the make and did not know if 3amp would be sufficient enough.   Alan    

Found a BEC on ebay   TURNIGY 3A UBEC with Noise Reduction   was wondering if this would be good enough to run 4 analog servos.   Alan

What would you class as a good BEC so many different types and makes not sure what to go for.

  But the spec say 5amp capabiltiy I thought that would be plenty for 4servos.

Got my ESC today was sent the LITE ICE 75amp instead this should still be OK, the only thing I noticed was the manual stated that if you are uing over 3cell lipo's you should use a separate BEC but also say's that the max current capabilty of the BEC is 5amp.   PDF for all CC ESC   Should this still be OK or should i put in a seperate BEC.   Thanks Alan

i take it 5amps would be good enough to run 4 hitec servos HS225MG   hitect servo spec   Not sure what the 5amp meansEdited By Alan on 27/02/2011 17:12:17

What would be considered a good make BEC.