Vintage

Hi.....fly well the model with short nose?

Congratulations!! I like very much! I'd like to this work to the Puppeteer. Did you add lead for balance it?

Hi Jeff2wings.........this model showed in pictures is it a Flair Legionaire modified with short nose?

😄What do you think of the changes on my Flair SE5a

I am truly sorry that your SE5A was destroyed!

Hi everyone. I just have to make the last changes to the tailplane

Hi everyone. Do you have any question about all the changes? Here these beautifull photos The headrest enlarged using a 2,5mm balsa rectangular softened with steam/vapor. Pins and aliphatic glue.

Tailskyd

ASP 52 four stroke. Ok i added two 0,4mm panels on top of stringers. But i worked with steam/vapor, by putting the panels inside pot 5 minutes. I covered the small panel with aluminium adhesive.

Hi! I'll follow you with pleasure. Look at this pictures from internet

Ok I added more balsa and wood strips. I used cardboard. for cut the last form/ordered of balsawood To insert it inside and behind, I cut the central parts and the base. I took the measurement the same as the one form/ordered next to it. ONE other photo of precedent work!

Ok, if you look the real plane the top fuselage has three dimension and i enlarged near the cockpit.

Ok the 4 hole, used minidrill and various cutters. Two and of nitro putty and radiator+engine cowl is ready to paynt.

Radiator cap. The material beechwood. I used small lathe bought from Aliexpress.

Thank you for interest. Having modified the nose, but only just in height (I didn't widen the fuselage sides!). Ok, to follow the shape of the radiator i added soft balsa, on engine cowl. My technique is to drill (1,5mm)hole and introduce drops of cyanoacrylate (thin) very fast. After aliphatc glue, but just near the last hole and again Thin CA. NOTE: be careful to do not stick your finger, use transparent tape or transparent glove from supermarket. And fine tubes for CA container for introduce small drops!