Woowoo

Now there’s one for the memory bank(if I can remember where it is!). Though it makes perfect sense now, I would never have thought about that! Paul

These instructions should cover your esc. A long winded way to do it but is the only way without a programming card. **LINK**

First thing to check is throttle calibration. Basically ensures the esc knows the minimum and maximum positions of your transmitters throttle stick. Switch on transmitter and open throttle to full and then connect battery. You should hear a short tune or series of beeps from mother, then reduce throttle to minimum. Re check and throttle should be ok. If not I’ll try finding how to set timing without a programming card. Paul

CG sounds about spot on. I set my control surfaces to 15mm + / - all round but Then I do tend to fly on the edge! You may also need to add a bit of weight to the nose depending on battery size. I sometimes fly fpv with a 1500 4 cell so the added weight of fpv camera and go pro it balances just nice at 210 mm but without fpv I use 2200 3 cell to balance out without adding weight.

On the top face that’s coloured one spar goes just a couple of inches from motor mount, and on the lower face that’s plain foam again one is couple inches or so from motor mount and third spar goes in between the cutouts for esc/receiver and battery cutout. Paul

An absolute blast to fly, especially on the fast setup. The 3 carbon rods are glued across the wing joint. There should be grooves pre cut in the foam the rods are pushed into and glued i used hot glue for this. I also covered the edges with reinforced tape to protect them. There are a few youtube videos covering the build on the new one if you are still stuck i can upload pictures showing where the rods go. Paul

lThanks Bob, I gave them a call and a fresh copy being sent out! Paul

My May edition jus came through the post and I thought I would have a sneak look before heading back to work but it starts on page 23!! What’s happened to pages 2 - 22?!!!! Anyone else found this or is it a one off mishap? Paul

1. Oodallaly 2. Ballerina 3. Dragon Dancer Ii

1. Oodalally 2. Harlequin 3. Ballerina