Scruffmeister Posted October 21, 2011 Share Posted October 21, 2011 I'm nearly ready to cover my Fusion Micro, but have noticed that the elevator has a slight warp. About 4mm at one tip when laid on a flat surface. He structure is built up from ply/balsa. What would you recommend is the best way to fix, or will Solarfilm pull it into shape if heated on flat surface anyway?Thanks. Quote Link to comment Share on other sites More sharing options...
Stephen Grigg Posted October 21, 2011 Share Posted October 21, 2011 I had quite a warp on the horizontal stabiliser on my Radio Queen which badly affected the handling.I straightened it by holding it in the opposite direction as the warp and playing my heat gun over it.Of course it ais covered. Quote Link to comment Share on other sites More sharing options...
Alan Cantwell Posted October 21, 2011 Share Posted October 21, 2011 put it over a kettle, and steam it, twisting the opposite way, check as you are doing it, then weight it down until the balsa drys, best to wear a pair of gloves for this, and be carefull!! Quote Link to comment Share on other sites More sharing options...
Wiltshire Flyer Posted October 22, 2011 Share Posted October 22, 2011 I too have found that applying a little more heat to opposite side to the warp sorts out most minor warps. Keep an eye on it though as it weathers as it may well creep back as the covering slackens. Quote Link to comment Share on other sites More sharing options...
Scruffmeister Posted October 23, 2011 Author Share Posted October 23, 2011 Thanks all, will try and straighten with steam before I cover as much as possible... and hopefully the covering will do the rest. Quote Link to comment Share on other sites More sharing options...
Seamus O'Leprosy Posted October 23, 2011 Share Posted October 23, 2011 mind your fingers! Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.