Johnnie Posted August 16, 2013 Share Posted August 16, 2013 Can anybody tell me what size of wheels they have used in this project. I know they are 90mm but what thickness can you fit into the wings with the retracts. Thanks in advance. Quote Link to comment Share on other sites More sharing options...
alan p Posted August 17, 2013 Share Posted August 17, 2013 Unless you use very narrow wheels, the wheel well wing rib will have to be reduced in depth to allow leg and wheel to sit flush on retraction. Quote Link to comment Share on other sites More sharing options...
Johnnie Posted August 17, 2013 Author Share Posted August 17, 2013 Thanks Alan. So what width of wheel should I be looking for. No problem to reduce the well rib but would want to keep that to a minimum. ~Would 30mm be OK along with the leg which is about 10mm diameter. Would this still leave enough rib or do I need to look for something thinner. Quote Link to comment Share on other sites More sharing options...
Biggles' Elder Brother - Moderator Posted August 17, 2013 Share Posted August 17, 2013 Johnnie, checking from the plan I'd say, that without any alteration, the depth of the well - at the maximum point - is about 33mm, and at the shallowest point is about 30mm. That would have to hold the wheel, the leg and the thickness of the door. In the only other build blog I've found the writer does significantly deepen the well. BEB Edited By Biggles' Elder Brother - Moderator on 17/08/2013 21:35:57 Quote Link to comment Share on other sites More sharing options...
Johnnie Posted August 18, 2013 Author Share Posted August 18, 2013 BEB I am following your build blog with great interest. Just happenning at the right time for me. Have you identified which wheels (front & Back) that you are going to use in your build. Johnnie Quote Link to comment Share on other sites More sharing options...
Johnnie Posted August 19, 2013 Author Share Posted August 19, 2013 Anybody know what wheels Tony Nijhuis used in the original build. Johnnie Quote Link to comment Share on other sites More sharing options...
Biggles' Elder Brother - Moderator Posted August 19, 2013 Share Posted August 19, 2013 Sorry Johnnie I didn't mean to not answer - I somehow didn't notice your question to me. No I haven't looked at wheels yet. And I don't know what Tony used - but I believe they were 3.5 inch diameter. I'm planning to have a good look round at the Nats. BEB Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.