Bigglesworth Posted October 1, 2017 Share Posted October 1, 2017 Since updating my 18SZ tranny to V3 software I have had a problem setting the throttle failsafe position when using the TX in FASST 7. There was no way to set the throttle failsafe! I found a work round by temporarily changing the TX setting to FASST Multi, setting the throttle faulsafe position, then changing the TX back to FASST 7. This worked perfectly but it should not be neccessary to do this. There is a glitch in the software in V3 which Futaba must fix. Quote Link to comment Share on other sites More sharing options...
Denis Watkins Posted October 1, 2017 Share Posted October 1, 2017 The failsafe is in the receiver Does that help Quote Link to comment Share on other sites More sharing options...
Bigglesworth Posted October 2, 2017 Author Share Posted October 2, 2017 The failsafe is in the rx but the tx sends a signal to the rx to let it know the failsafe position. It worked fine before I installed v3 software update. Quote Link to comment Share on other sites More sharing options...
Bigglesworth Posted November 8, 2017 Author Share Posted November 8, 2017 The latest update released, V3.1, has rectified the problem. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.