StuPos Posted March 1 Share Posted March 1 Has anyone else had an issues with Yep 60amp Esc? I have 4 which are not usable. One after working fine just decided just to produce a pulsing, half power!! The other 3 have the same issue, but this is after 'heavy' landings in each case - over a few years. There is no visual damage or burn-out of a component. I have tried reseting all the parameters with a programme card with no improvement. Any suggestions other than the bin? Quote Link to comment Share on other sites More sharing options...
Denis Watkins Posted March 1 Share Posted March 1 (edited) Stu, the ESC are very versatile and easily BEEP - Beeped into an unwanted programme sequence, so look again here At the Frequency too Edited March 1 by Denis Watkins Quote Link to comment Share on other sites More sharing options...
SIMON CRAGG Posted March 1 Share Posted March 1 I had similar faults and binned all of mine (6). Way to complicated with the programme card(s), and a bit of messing about with disconnecting the red power feed. Never really trusted them, and certainly not el cheepo. Sywalker V2 for me these days. Quote Link to comment Share on other sites More sharing options...
StuPos Posted March 4 Author Share Posted March 4 Thanks for that Dennis. I'll have a go - it does seem as though the Esc has jumped to different 'angle of entrance'. I thought I had been through all the variations with the programming card. I see there is a reset on your list, I can try that if not getting anywhere. Stuart Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.