Mike White 3 Posted July 16, 2015 Share Posted July 16, 2015 Hello All, attempting to set up flaperons on T8J, use VR as flaps control gives both surfaces up if VR anti clockwise, flat if centered and down if fully clockwise, not ideal changed VR to use a 3 position switch gives same results, have played with values in 'Flaperon' section of menu but cannot figure out how to completely remove all up movement with out removing movement when using aileron function, have tried manipulating 'flap trim' values, still no success. Is it possible to set down deflection only when using 'flap' control? Michael Quote Link to comment Share on other sites More sharing options...
Andy Green Posted July 16, 2015 Share Posted July 16, 2015 Hi Mike You need to look at the Offset command, Not sure what it looks like on a T8J. Have you seen Malcolm Holts book on the 14SG, sure some of the programming methodology is similar. Andy Quote Link to comment Share on other sites More sharing options...
Mike White 3 Posted July 20, 2015 Author Share Posted July 20, 2015 Thanks for suggestion Andy, not an 'offset' function as such on T8J, exchanged several emails with 'Futaba' support, even after following instructions given, still cannot remove 'up' deflection. They never actually said it could be done, not had an answer back for my last question which was specifically asking ' can it be done? Michael Quote Link to comment Share on other sites More sharing options...
Jon H Posted July 20, 2015 Share Posted July 20, 2015 when both ailerons are up remove the output arm from the servo and reset it for centre. I had the same issue and this was the easiest fix as I couldn't be bothered to argue with the programing all day long Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.