Den Moran Posted May 16, 2019 Share Posted May 16, 2019 Hi, everybody! I have a Dynam Me 262 - the type has had problems with the ESCs overheating - there is a good vid on youtube showing one catching fire in the air (luckily only minimal damage) ! I'm looking at emplacing a BEC system, to offset the overheating problem, and need a wiring diagram for a TWIN setup. I know about ducting air over the esc's etc., but, really, I'm just asking about BECs for twin setup. Thank you, Den, Abertawe. Quote Link to comment Share on other sites More sharing options...
Nigel R Posted May 16, 2019 Share Posted May 16, 2019 Connect main lipo to BEC, in parallel with the ESCs. Connect BEC to RX Ensure red wire from ESC (both of them) is not connected to the RX (usually the pin can be carefully removed from the plug) Does that still need a wiring diagram? Quote Link to comment Share on other sites More sharing options...
Gary Manuel Posted May 16, 2019 Share Posted May 16, 2019 . Edited By Gary Manuel on 16/05/2019 10:59:27 Quote Link to comment Share on other sites More sharing options...
Den Moran Posted May 16, 2019 Author Share Posted May 16, 2019 'Does that still need a wiring diagram?' - I'm afraid it does, Nigel, because I want the power supply to the servos to be independent of the main Lipo, otherwise there is little point in using a BEC, other than in large capacity situations. Quote Link to comment Share on other sites More sharing options...
John Lee Posted May 16, 2019 Share Posted May 16, 2019 Here you go Quote Link to comment Share on other sites More sharing options...
Nigel R Posted May 16, 2019 Share Posted May 16, 2019 if only you'd said... Connect second battery to BEC. Connect BEC to RX Ensure red wire from ESC (both of them) is not connected to the RX (usually the pin can be carefully removed from the plug) Edited By Nigel R on 16/05/2019 13:21:56 Quote Link to comment Share on other sites More sharing options...
Den Moran Posted May 17, 2019 Author Share Posted May 17, 2019 Thanks , Nigel, and sorry for the confusion! John, that's absolutely nailed it for me, just what I was after, I'm afraid I'm a little challenged with electronics side of our hobby! Happy flying! A great response as ever, thanks again, Den, Swansea Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.