Mal Quelch

Bob, thats a big aerial you have there! 35Mhz. Could it be interference from two switch mode bec`s? Sometimes one is enough to cause problems and you have doubles of everything.Trying to keep maximum separation may be difficult for you.

Bob, another thing you could try is another Transmitter, your problem seems to be affecting both motor systems, could it be a dirty or bad track on that stick axis? Maybe try driving it with a servo tester or from a different channel BUT be aware you will have to make sure stick is held low when switching on or the motor may start up - but I think the hobbywing series have safeguards to prevent it. Mal

Yes please David, I really need something to cheer me up.

Board came today, many thanks. Will be some time before I can do anything with it.

I was going to suggest a dirty on/off switch in the Tx during switch off, thus failing to save settings. Loose cell did just that it seems. P.S. I never took to spektrum so am not a user.

I am getting used to the differences now and not found anything to dislike so far. One suggestion though, long long ago you could set to go to the last post in a thread( i`m pretty sure). As it stands at the moment you have to scroll all the way down to get to it. When you get there and find just a `smiley` or a +1 it gets a bit frustrating, especially if you are catching up on a few days worth. It would be much easier to scroll up from the last post to where you were last. What do others think?

Yes please, depending on weight of course, maybe a ducted fan model.

Joe / Alan, just a thought but have you eliminated a bad or dirty track on your throttle channel on your transmitter? That could cause the same symptoms.

My copy came at the end of june and I had a cursory scan through before rushing to QA hospital in Portsmouth concerning my Father. As a result I havent been on here for some time. I have been wondering which section to ask this question, having searched and seen no prior reference. Page 16 Photo `Steve Carr`s Extra 260` Whats with the 4 cell battery on the tail skid?

Andrew, On the plan do you have two wings (L&R) or are they superimposed such that you build one at a time over the same drawing? If that is the case are you expected to build a particular wing first and could that explain it? Mal

Yes please - me too. Shame there is no RCM&E hat up for grabs! (hint hint)

Yes please, anything will do nicely thanks

Yes please - pick me something nice!

Hi all, This may not be the same problem but i have had spinner run out also. Not only with this type fitting but also with collet type. Using APC `style` Electric props. In my case I found that when tightening the prop the raised prop size (8x4 10x6 etc) on the front boss , being on one side, stopped the spinner tightening up level. The prop ran true but the spinner appears off centre. Might be worth a look ? All I did was face the lettering off level and it was fine. You could try tightening say a nut, or stack of washers in place of a prop and see if it changes anything? Simple I know but worth checking. Mal

Yes please - it`s got to be worth a try!