Brian Dorricott 1 Posted September 18, 2022 Share Posted September 18, 2022 Hi, We had a new club member turn up with 2 brand new DX6e transmitters and a nice Boomerang trainer complete with Irvine 52 , he had buddied up the DX6e to each other ready for a bit of supervised flying but the future plan was to fly with his grandson ( good idea). We started and tuned the Irvine and tested the controls all went the same way , all good . As it was a bit busy with one of our tame lunatic " throttle don't use them" fliers hooning around at 100mph everything was switched off for 10 minutes and when switched on again the student TX had lost its bind . Rebound everything looked OK and the flight went well but after being switched off again the student became unbound , thinking something odd we tried to bind but no joy so we swapped the TX around so the other was the master but still no joy binding them despite standing 15 feet away shielding the TX with your body ( known speccy problem) . A DX8 was pressed into master service and one the DX6e tried to bind under trainer again but "bind failed" so another DX8 was used as student and all was well . At no point did the DX6e lose bind to the aeroplane just each other in trainer mode , we have a regular flier whose uses a DX8e as master every week with no problems and finally both DX6e are up to date software versions - so anyone any ideas why ? Thanks in anticipation. Quote Link to comment Share on other sites More sharing options...
Denis Watkins Posted September 18, 2022 Share Posted September 18, 2022 As you said Brian, the DX6e acquires the Slave Tx as it would a receiver, but there is a specific Mode in the Set up on this Bind proceedure. am just going through the manual. Quote Link to comment Share on other sites More sharing options...
Keith Billinge Posted September 18, 2022 Share Posted September 18, 2022 Beleive you have to turn the TX's on in the correct sequence. If you turn on the master then wait for a few seconds....then turn on the Slave....then the model. Get the order wrong and it won't work. This is my understanding. KB Quote Link to comment Share on other sites More sharing options...
Denis Watkins Posted September 18, 2022 Share Posted September 18, 2022 Pilot link master, page 21 Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.